SBB key programmer instruction manual and operating methods |VtoolShop

The SBB key programmer is provided with a password to prevent unauthorized use. Users have at their disposal a functions menu to meet all possible requirements during operation.

• SBB User Manual English.pdf (11MB)

SBB key programmer main characteristics operating methods

- Adds or deletes keys and remote controls from the immobilizer control unit by connecting SBB to the vehicle diagnostics input.

SBB key programmer special functions

Storage in the User Data Archive of all operations carried out; Multi-language program; Machine test;

Read the PIN CODE (where possible);

Help (operational help for: type and position of connectors, procedures, keys, types of transponders, etc...).

SBB key programmer password

A principle password is needed to enable SBB key programmer (required every time the program is turned on), issued by the supplier/distributor by means of a special "USE AGREEMENT FORM".

 - full loaded configuration


SBB key programmer software update (new makes released)

- To use the new makes loaded with the SW update (after purchase) you may proceed in two different ways:

Enabling by password

Enter a different password specific to each new make released (see Ch.“Enabling”) then you can always use the device for that given make.

Apply for the passwords on the special form "USE AGREEMENT SHEET“ included in the software update kit .

Enabling by token

Use a credit that is reduced every time key programming/deletion is carried out. Credits can be purchased and loaded onto SBB by means of a smart card (see chap. 6.6.1 ENABLING" ).

More Detail about how SBB key programmer works:

Even if all of your keys get lost, SBB key programmer also can make sure you get a new key.

1 Before running SBB Key Programmer, please insert the blank new key into your car keyhole;

2 turn on ignition switch;

3 Insert SBB 16-pin interface into your car OBD2 diagnostic seat.  SBB Key Programmer copies chip according to car model, and it program key not clone key, it only needs to insert SBB

16-pin interface into your car OBD2 diagnostic seat, then read out immobilizer pin code from immobilizer dump/eeprom of the car before writing it into new blank key. When Programming Ford vehicle, it does not need pin code.

SBB key programmer read pin code supports：

SBB Key Programmer support read pin code for Honda, Acura, Volkswagen, Toyota and Nissan. It needs pin code to read Volkswagen and Nissan, no need pin code to read Honda and Toyota.

NOTE: Once the SBB key programmer is connected to the power mains it’s automatically switched on. To turn it off exit from function and unplug the machine from the mains.